Author Topic: Aluminum Firewall option...  (Read 206 times)

aarvig

  • Hurricane Owner
  • *
  • Posts: 110
    • View Profile
    • Email
Aluminum Firewall option...
« on: September 18, 2017, 03:55:40 pm »
Hey guys,
Getting ready to put the aluminum firewall together and wondering if anyone with the 20xx gen cars has some photos of the firewall aluminum in place.  I'd appreciate it!
Now I lay rubber down the street, I pray for traction I can keep, but if I spin and begin to slide, please dear Lord, protect my hide.

Russ Rittimann

  • Hurricane Owner
  • *
  • Posts: 178
  • Hurricane Motorsports
    • View Profile
    • Email
Re: Aluminum Firewall option...
« Reply #1 on: September 19, 2017, 05:50:14 am »
Here's mine.  I only have the single piece aluminum firewall.  I just installed it over the fiberglass.  No insulation.

Russ

Russ
HM-2005
KC-408, Tremec 600, IRS

mandmGuys

  • Hurricane Owner
  • *
  • Posts: 245
  • Hurricane Motorsports
    • View Profile
    • Email
Re: Aluminum Firewall option...
« Reply #2 on: September 19, 2017, 07:20:47 am »
Cannot post one have not tried to fix photobucket yet. Send via email

Mark

aarvig

  • Hurricane Owner
  • *
  • Posts: 110
    • View Profile
    • Email
Re: Aluminum Firewall option...
« Reply #3 on: September 22, 2017, 08:53:05 am »
Russ!  Who are you using to host your web photos?
Now I lay rubber down the street, I pray for traction I can keep, but if I spin and begin to slide, please dear Lord, protect my hide.

Russ Rittimann

  • Hurricane Owner
  • *
  • Posts: 178
  • Hurricane Motorsports
    • View Profile
    • Email
Re: Aluminum Firewall option...
« Reply #4 on: September 23, 2017, 06:46:40 am »
I reduce the size then upload them directly to the forum.  I keep my photos on my computer at home backed up on a portable drive.  I use IrfanView to reduce the size.  It's a free photo viewer/manipulator program.  No hosting.  I'm not that techno smart.

Russ
Russ
HM-2005
KC-408, Tremec 600, IRS

dawger

  • Hurricane Owner
  • *
  • Posts: 10
    • View Profile
Re: Aluminum Firewall option...
« Reply #5 on: September 23, 2017, 09:14:34 am »
Aaron,
All I have is the upper portion if the firewall aluminum. I believe Mike and Mark have the full aluminum panels. I glued some leftover trans tunnel heat shield to the back of mine then attached to the firewall with pop rivets. Mine was long enough to where I bent a lip to extend under back towards the rear to match the angle of the tunnel.

Michael